LANZHOU UNIVERSITY OF TECHNOLOGY
毕业设计
题 目 基于Multisim的锁相环解调系统仿真
学生某某
学 号
专业班级
指导教师
学 院 计算机与通信学院
辩论日期
基于Multisim的锁相环解调系统仿真
PLL Demodulation System Simulation Based on Multisim
摘要
实现调频波解调的方法有很多,而锁相环鉴频是利用现代锁相环技术来实现鉴频,具有工作稳定,失真小,信噪比高等优点,所以被广泛用在通信电路系统中。锁相环其原理是通过鉴相检测输入信号和输出信号的相位差,并将检测出的相位差信号转换成电压信号输出,
该信号经低通滤波器滤波后形成压控振荡器的控制电压,对振荡器输出信号的频率实施控制。
该文首先介绍了锁相环技术开展的现状、方向以与背景,并对PLL的原理进展了阐述。在以上的根底上,分别设计了2ASK、2PSK、2FSK的调制解调电路,其功能为数字基带信号经过调制输出一个模拟信号,然后用锁相环进展解调,最后采用Multisim软件进展仿真。在对2ASK、2FSK、2PSK解调时,低通滤波器输出的波形失真比拟大,不过最后经过抽样判决电路整形后可以再生数字基带脉冲。在整个电路设计中,力求要做到电路简单,并完成任务书提到的要求。
关键词:调制;解调; Multisim;锁相环
Abstrack
There are many ways to realize frequency wave demodulation, and PLL frequency which has the advantages of stable operation, small distortion, high signal-to-noise ratio and so on is achieved by using modern PLL frequency technology, so it is widely used in municat
ion circuit system. Phase-locked loop through the difference of the phase detection of input signal and the output signal phase, and the detected phase difference signal into output voltage signal, the signal through a low pass filter. After the formation of the voltage control oscillator , the output signal of the oscillator frequency control.
This paper first introduces the present situation, development direction, phase-locked loop technology as well as the background, and the principle of PLL is discussed. On the basis of the above, the modulation and demodulation circuit of 2ASK, 2PSK, 2FSK which function is a digital baseband signal is modulated by an analog signal and output were designed, and then useing the PLL demodulation, finally using Multisim software simulation. In the 2ASK, 2FSK, 2PSK demodulation, the output of the low pass filter waveform distortion is relatively large, but finally it can regenerate digital baseband pulse sampling decision circuit after shaping. In the circuit design, and strive to do a simple circuit, and plete the task book mentioned requirements.
Keywords: modulate ;modulation ;PLL;Multisim
版权声明:本站内容均来自互联网,仅供演示用,请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198,我们将在24小时内删除。
发表评论