BEFORE BEGINNING
This manual and everything described in it are copyrighted.  You may not copy this manual, in
whole or part, without written consent of Matsushita Electric Works, Ltd.
Matsushita Electric Works, Ltd. pursues a policy of continuous improvement of the design and
performance of its product, therefore, we reserve the right to change the manual/product without
notice.  In no event will Matsushita Electric Works, Ltd. be liable for direct, indirect, special,
incidental, or consequential damage resulting from any defect in the product or its documentation,
even if advised of the possibility of such damages.
LIMITED WARRANTY
All implied warranties on the product, including merchantability and fitness, are limited to one
year from the date of purchase.
If physical defects caused by distribution are found, Matsushita Electric Works, Ltd. will replace/
repair the product free of charge.  Exceptions include
When physical defects are due to a different usage/treatment of the product than described in the
manual.
When physical defects are due to defective equipment other than the distributed product.
When physical defects are due to modification/repair by someone other than Matsushita Electric
Works, Ltd.
When physical defects are due to natural disasters.
Introduction
delete in
The FP Programmer II is a handy type of programming tool for FP series programmable
controllers FP1, FP3, FP5, FP10S, FP10, FP-C and FP-M.
With the FP Programmer II, you can enter, change, insert, and delete instructions written in the
internal RAM of the programmable controller (CPU).  With the key operations on the FP
Programmer II, you can easily edit the program.
It also provides so called “OP Functions” with which you can monitor or change ON/OFF status of
relays or register values stored in the programmable controller, or set system register parameters.
The FP Programmer II can be used as a program carrier.  You can upload a program from the
NPST-GR, an FP series programming software, or a programmable controller and store it
temporarily in the FP Programmer II.  Then you can download it to the NPST-GR or
programmable controller.  This function may be convenient for you to carry program when you
cannot easily connect your computer with the programmable controller because of ventilation.
This manual explains how to use the FP Programmer II.  Chapter 1 overviews the FP Programmer
II and explains how to connect it with the programmable controller.  Before operating FP
Programmer II, read this chapter to understand the keys on the FP Programmer II.  Chapter, 2, 3
and 4 explains how to edit the program.  Chapter 5 explains about OP Functions, and Chapter 6 are
about the program carrier function.
For details of program instructions, system register assignments, relay and register numbers, refer
to appropriate manual such as, the programming manual, hardware manual, and others.

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。