HP Designjet 800PS 日常维护
Page i
目录
1 HP Designjet 800PS简介 (1)
generic是什么牌子打印机
2 HP Designjet 800ps常规配置 (2)
2.1 IP地址的配置 (2)
3 常见故障解决方案 (4)
3.1 前面板报“系统错误 61:05” (4)
3.2 前面板报05:10错误 (7)
4 附录：错误代码速查 (10)
Page ii
1HP Designjet 800PS简介
HP Designjet 800ps 是hp的一款大幅面绘图仪，主要用于打印A0和A1篇幅的海报，CAD图纸等。
Page 1
2HP Designjet 800ps常规配置
2.1IP地址的配置
NOTE:  A delay of approximately 30 seconds may be expected between each step.
1. From the Front Panel, use the arrow buttons to highlight the printer icon and press ENTER.
2. Press the Up arrow key until I/O Setup appears. Press ENTER.
3. Press the Down arrow to Card Setup and press ENTER. Highlight Configuration, and press ENTER.
4. From the Front Panel message of Cfg Network=No, press ENTER.
5. Press the Up arrow key to change to Yes. Press ENTER.
6. Press the Up arrow key until Cfg TCP/IP=No appears. Press ENTER.
7. Press the Up arrow key to change to Yes. Press ENTER.
8. Press the Up arrow until BOOTP=Yes appears. Press ENTER.
9. Press the Up arrow key to change to No. Press ENTER.
NOTE:If BOOTP=Yes, the printer is configured to retrieve its TCP/IP parameters over the network from a BOOTP, RARP, or DHCP server. If BOOTP=NO, the printer is configured to accept TCP/IP parameters
from the Front Panel.
11. On HP Jetdirect print servers with firmware L.20.04 or greater, press the Up arrow key to until DHCP=yes
appears. Press ENTER.
12. Press the Up arrow key to change to No. Press ENTER.
13. Press the Up arrow key until IP Byte1=xxx appears.
14. To change the IP byte, proceed as follows:
a. Press ENTER.
b. Press the Up or Down arrow key to change the number.
c. Press ENTER.
d. Press the Up arrow key to continue to IP Byte2=xxx.
e. Press ENTER.
15. Configure the remaining bytes of the IP address in the same manner.
16. Configure the subnet mask bytes (SM), syslog server IP address (LG), default gateway (GW), and timeout
(TIMEOUT) in the same manner.
NOTE:When the HP Jetdirect print server is given a syslog server IP address, it can generate syslog messages and send them to that. If no syslog server is on the network, skip this setting.
Page 2
18. The TIMEOUT parameter default is 90 seconds. Up to 3,600 seconds can be configured. If set to "0," the
timeout feature of the HP Jetdirect print server is disabled -- TCP/IP connections will remain open until
closed by the server.
19. To save this information:
a. Designjet 5000: Press the BACK button three times, then press the TOP button to save the
configuration.
b. Designjet 500 and 800: Press the BACK button four times and wait until the Ready message is
displayed.
c. Turn the printer off, then turn it on to refresh the new settings.
Page 3

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。