TEST REPORT
IEC 60598-2-1 and/or EN 60598-2-1
Part 2: Particular requirements
Section One – Fixed general purpose luminaires
Report Reference No.    :
   
Tested by (name+signature)    :
   
Witnessed by (name+signature)    :
   
Supervised by (name+signature)    :
   
Approved by (name+signature)    :
   
Date of issue    :
CB/CCA Testing Laboratory    :
Address    :
Testing location/ procedure    :
CBTL        RMT        SMT        WMT        TMP   
Testing location/ address    :
Applicant’s name    :
Address    :
Test specification:
Standard    :
    IEC 60598-2-1:1979+A1:1987 used in conjunction with
    IEC 60598-1:2003
    EN 60598-2-1:1979+A1:1987 used in conjunction with
    EN 60598-1:2004
Test procedure    :
CB / CCA
Non-standard test method…………..:
N/A
Test Report Form No.    :
IECEN60598_2_1A
TRF Originator    :
Intertek Semko AB
Master TRF    :
Dated 2004-09
Copyright © 2004 IEC System for Conformity Testing and Certification of Electrical Equipment (IECEE), Geneva, Switzerland. All rights reserved.
This publication may be reproduced in whole or in part for non-commercial purposes as long as the IECEE is acknowledged as copyright owner and source of the material. IECEE takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context.
Test item description    :
Trade Mark    :
Manufacturer    :
replaceableModel/Type reference    :
Address    :
Ratings    :

Copy of marking plate
Summary of testing:

Test item particulars    :
Possible test case verdicts:
- test case does not apply to the test object    :
N/A
- test object does meet the requirement    :
P(Pass)
- test object does not meet the requirement    :
F(Fail)
Testing    :
Date of receipt of test item    :
Date (s) of performance of tests    :
General remarks:
This report is not valid as a CB Test Report unless signed by an approved CB Testing Laboratory and appended to a CB Test Certificate issued by an NCB in accordance with IECEE 02.
This report is not valid as a CCA Test Report unless signed by an approved CCA Testing Laboratory and appended to a CCA Notification of a CCA Notification of Test Result issued by an NCB in accordance with a CCA Group Permanent Documents.
The test results presented in this report relate only to the object tested.
This report shall not be reproduced, except in full, without the written approval of the Issuing testing laboratory.
"(see Enclosure #)" refers to additional information appended to the report.
"(see appended table)" refers to a table appended to the report.
List of test equipment must be kept on file and available for review.
Throughout this report a comma (point) is used as the decimal separator.
In this report requirements valid for EN only are marked with (EN).
General product information:

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。