replaceable
12
or
3
> 200 times
Detection Angle
Number of Detection
(when fully charged)
Test
1. Turn on the switch firstly;
2. Cover the solar panel before test;
3. Put the lamp under the sun for 6-8h, if it doesn't work.
640001
640002
Choose a location exposed to direct sunlight. Recommended height :1.8-2.5M.
Turn the switch on
1
2
3
1. After the switch is turned to the “ON” position, the wall light only illuminates when the ambient light
level is below 20 Lux and there is human movement detected.
2. The number of uses depends on the amount of electricity stored during the daytime, which is affected by the intensity and duration of sunlight.
3. Temperature affects the sensitivity of the PIR sensor, causing the detection range to vary. The higher the temperature is, the shorter the detection range will be.
4. If the light fails to light up after days of continuous rainy or cloudy weather, it is because the battery has been exhausted. The light will function normally again at night after a sunny day.
5. Please turn the switch on firstly; If the lamp doesn't work, please install the lamp in a location exposed to direct sunlight, and charge it for 6-8h before 1st time use.
6. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。