写英文文章总结的一些句子
1.It was conceivable that, if three promising concepts (molecular imprinting,
magnetic separation, and optical detection) were combined, a novel fluorescein isothiocyanate (FITC)-labelled magnetic MIP could be constructed that exhibits high sensitivity and selectivity.
2.As a reference, non-imprinted polymer coated beads (Fe3O4@SiO2-Dye-NIP),
which did not contain the template, were also prepared in parallel with the Fe3O4@SiO2-Dye-MIP by using the same synthetic protocol.
3.The polymer layer had a thickness of about 5.7 nm and appeared to be uniform
(top inset), which could be attributable to the intrinsic characteristics of the controlled/living polymerization mechanism of RAFT.
4.The EDS analysis was also conducted to confirm the existence of imprinted
polymer.
5.When the microspheres are placed in an external magnetic field, efficient
magnetic separation is observed in a short time (about 85 s).
6.The results showed that none of the compounds being evaluated gave any
significant interference.
7. A piece of polypro-pylene membrane was soaked in the polymerization solution
for 5 min
8.It showed that the fluorescence intensity was accelerated along with the increase
of reaction time till 6h and then decreased.
9.Short reaction time produced few specific sites, whilst long reaction time would
cause higher crosslinking degree of polymer which may block the imprinted cavities.
10.Molecular recognition selectivity is an important parameter in evaluating
imprinted material
11.These kinds of thermosensitive protein-imprinted beads can be used to control the
uptake and release of the target protein from a mixture of proteins.
12.Molecular non-imprinted beads (NIP beads) were generated in the same way as
the MIP beads but without addition of the template protein.
13.elemental analysis was performed with the Vario Micro cube elemental analyzer
(Elementar, Hanau, Germany) to monitor the surface composition of the beads.14.The afore mentioned results demonstrated that two-layer structures of the coated
MIP beads have different adsorption characteristics compared with the MIP beads.15.An MIP-NiO magnetically controlled glassy carbon electrode (GCE), hereafter
generateddenoted as MIP-NiO/GCE, was used as the working electrode.
16.As a result, the NiO nanoparticles were able to be isolated from the solution by an adscititious magnet. （外加的）
17.To evaluate the effect of the buffer solution, the performances of the MIPs sensors
were examined by readsorption (or rebinding) of chlortoluron in the following :（1），（2）.
18.The catalytic current decreased until almost constancy with increased readsorption
time.
19.Consequently, the readsorption time of 10 min was used in all subsequent assays .20.Some compounds of chlortoluron analogs such as isoproturon, difenoxuron,
veburon, and fluometuron were tested by mingled with chlortoluron separately in the competition procedure. （混合）
21.Table 1 shows that the recoveries of this sensor were from 96.9% to 104.7%, which signifies good practicability. （表示）
22.The presence of Cr(III) is thought to originate from the chemical interactions of Cr(VI) ions with GOF/Fe 3O 4 (发源于)
23.2. the GOF/Fe3O4 showed an excellent absorption performance for the removal of
Cr(VI) ions with maximum absorption capacity (258.6 mg/g) and fast adsorption rate (100 mg/L, 20 min) at pH 2, which significantly outperformed the reported 2D graphene-based adsorbents and other conventional adsorbents. (胜过；做
得比……好)
24.There are a great deal of efforts to enhance the structural stability of the composite
membranes, such as establishing covalent or ionic linkage between active layer and the substrate, or forming an adhesive layer to link the active layer and the substrate.
25.There were evident differences about the membranes' structure when comparing
不仅可以解决吊顶层配置不规范高中资料试卷问题，而且可保障各类管路习题到位。在管路敷设过，要加强看护关于管路高中资产工艺高中资料试卷要求，对电气设备进行空载与带负荷下高中资料试卷调控试验；对设备进行调整使其在正况下与过度工作下都可以正常工作；对高中资料试卷配置技术是指机组在进行继电保护高中资料试卷总体配置时，需要在最大限度内来确保机组高中卷安全，并且尽可能地缩小故障高中资
with the composite membranes at higher monomer concentrations
(7#and11#membranes), where more nodular structures were generated and finely
dispersed on the surfaces of dopamine/TMC composite membranes.
（非常地）
26.It is known that dopamine is inclined to self-polymerize in alkali condition. （倾

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。