MIL-DTL-5541F铝和铝合金表面化学防护涂层 MIL-DTL-5541F 中英文版
超级中文标准网 超级中文标准网
MIL-DTL-5541F
SUPERSEDING 替代
MIL-C-5541E
30 November 1990 1990年11月30日
DETAIL SPECIFICATION
规范说明
CHEMICAL CONVERSION COATINGS
ON ALUMINUM AND ALUMINUM ALLOYS
铝和铝合金表面化学防护涂层
This specification is approved for use by all Departments and Agencies of the Department of Defense.
该规范适用于美国国防部所有部门和机构
1. SCOPE
1. 范围
1.1 of chemical conversion materials with the surfaces of aluminum and aluminum alloys
1.1该规范适用于铝制品和铝合金表面由于化学材料反应而形成的防护涂层。
1.2 The chemical conversion coatings are of the following types and classes. 分类.化学转换涂层分为以下类型和级别.
1.2.1 Types. The chemical conversion coatings are of the following types (see 3.1):
1.2.1 型号.化学转换涂层分为以下类型（见3.1）：
Type I – Compositions containing hexavalent chromium. 型号I-成分包含六价铬。
Type II – Compositions containing no hexavalent chromium.
型号II-成分不包含六价铬。
1.2.2 Classes. The materials, which form protective coatings by chemical reaction with
aluminum and aluminum alloys, are of the following classes (see 6.1 and 6.4).
1.2.2 级别.铝制品和铝合金制品通过化学反应形成的保护涂层的材料，分为以
下级别（见6.1和6.4）
Class 1A - For maximum protection against corrosion, painted or unpainted.
级别1A-用于最大防腐蚀、上漆或未上漆的防护涂层
Class 3 - For protection against corrosion where low electrical resistance is required 级别3-用于电阻值较低要求的防腐蚀涂层
2. APPLICABLE DOCUMENTS
2. 应用文件
2.1 General. The documents listed in this section are specified in sections 3 or 4 of this specification. This section does not include documents cited in other sections of this specification or recommended for additional information or as examples. While every effort has been made to ensure the completeness of this list,
document users are cautioned that they must meet all specified requirements of documents cited in sections 3 or 4 of this specification, whether or not they are listed.
2.1 概述.该部分所列文件在标准的3或4部分做过说明。该部分没有包括在本标准其他部分所引用的文件或推荐的附加信息以及文中所举例子。为了尽量满足该列表的完整性，文件使用者被要求必须满足3、4部分所引用文件的一切要求，不管其是否出现在列表中。
2.2 Government documents.
2.2 政府文件
2.2.1. Specifications and standards. The following specifications and standards form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.
2.2.1 规范与标准。以下规范和标准形成该文件的扩展规范。除非另行说明，该文件的条款将被引用在招标和合同文件中。
FEDERAL STANDARDS 联邦标准
FED-STD-141 - Paint, Varnish, Lacquer and Related Materials: Methods of Inspection, Sampling and Testing
FED-STD-141 –油漆、清漆、漆器和相关材料：检测方法、采样和测试
DEPARTMENT OF DEFENSE SPECIFICATIONS
国防部规范
MIL-PRF-23377 - Primer Coatings: Epoxy, High-Solids
MIL-PRF-23377 –底漆涂层：环氧树脂、高固体
MIL-DTL-81706 - Chemical Conversion Materials for Coating Aluminum and Aluminum Alloys
MIL-DTL-81706 – 用于铝制品和铝合金的化学转换材料涂层
MIL-PRF-85582 - Primer Coatings: Epoxy, Waterborne
MIL-PRF-85582 –底漆涂层：环氧树脂、水性
(Copies of these documents are available online at assist.daps.dla.mil/quicksearch or assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.这些文件的复印件可在网上获得，网址：assist.daps.dla.mil/quicksearch 或assist.daps.dla.mil，或通过从标准文件订单获得，地址：费城，4D大厦，700 Robbins大街，PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this
document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.
2.3 非政府出版物。以下规范和标准形成该文件的扩展规范。除非另行说明，该文件的条款将被引用在招标和合同文件中。
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
INTERNATIONALdegrade
美国国家测试与标准协会（ASTM）国际
ASTM-B117 - Salt Spray (Fog) Apparatus, Operating. (DoD adopted)
ASTM-B117 –盐雾设备，操作（DoD采用）
ASTM-D3359 - Adhesion By Tape Test, Measuring. (DoD adopted)
ASTM-D3359 –胶带粘性测试，测试（DoD采用）
(Copies of these documents are available from ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959 or 该文件复印件可从ASTM国际协会获得，地址：100 Barr Harbor Drive, West Conshohocken, PA 19428-2959 or ).
MIL-DTL-5541F
AMERICAN SOCIETY FOR QUALITY (ASQ) 美国质量协会（ASQ）
ASQ-Z1.4 - Procedures, Sampling and Tables for Inspection by
ASQ-Z1.4 –程序、采样和列表的属性检测
(Copies of this document are available from American Society for Quality, 600 North Plankinton Ave., Milwaukee, WI 53203 or . 该文件复印件可从
ASTM国际协会获得，地址：600 North Plankinton Ave., Milwaukee, WI 53203 or . )
SOCIETY OF AUTOMOTIVE ENGINEERS (SAE) INTERNATIONAL

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。