Apparel Product Standards
Measurement Guidelines for Finished Garments
All Measurements are taken with garment on flat surface。  All fullness and wrinkles should be smoothed out of garment， but garment must not be stretched.
Measurements are taken with garment closures in closed position unless otherwise specified。
TOPS
A.BUST
Measure straight across front of garment from side to side 1" below armhole, x 2 for
circumference.
               
B. ACROSS SHOULDER
Measure straight across back of garment where shoulder seam intersects top of armhole seam (shoulder point) to opposite shoulder point。
           
Apparel Product Standards
Measurement Guidelines for Finished Garments
C. ARMHOLE
Measure on curve along armhole seam from top shoulder point to bottom intersection of armhole seam and side seam， x 2 for circumference.
The armhole drop is measured using an imaginary straight line drawn from the outer top edge of the armhole or sleeve seam down to an imaginary straight line drawn horizontally through the lowest point of armhole when garment is placed flat and smooth with shoulder seams in a natural position。
                           
   
D.SLEEVE AT MUSCLE （UPPER ARM)
Measure straight sleeve in a line perpendicular to the fold line at the top edge of the sleeve.  Begin measurement point 1" away from armhole seam。
                   
APPENDIX C
Apparel Product Standards
Measurement Guidelines for Finished Garments
E.WAIST (tops)
  E1.  Measure straight across front of garment from side to side on a straight line at  right angles to the specified distance down from high point shoulder,  x 2 for circumference.
  E2。  Measure straight across front of garment from side to side at narrowest part of
front, x 2 for circumference。
  E3.  Measure straight across front of garment from side to side along the constructed
          waist seam, x 2 for circumference。
   
F.SWEEP (tops)
F1.  Measure along bottom curve of garment from side to side (garment closed)， x 2
      for circumference.
F2.  Measure along bottom curve of garment from front edge to front edge （garment
      opened）。
F3。  Sweater rib – measure along bottom of rib relaxed， x 2 for circumference.
Apparel Product Standards
Measurement Guidelines for Finished Garments
G. FRONT LENGTH
    From highpoint shoulder measure straight down front of garment to bottom。
H. BACK LENGTH
  H1。  From center of base of back neck seam measure straight down back of garment   
        to bottom。
  H2.  From high point shoulder measure straight down back of garment to bottom.
   
Apparel Product Standards
Measurement Guidelines for Finished Garments
I.  SLEEVE  LENGTH
I1。  From shoulder point at top of armhole, measure straight down to bottom of sleeve
      or cuff.
I2。  From the center of back neck （CBN） measure straight across to shoulder point at
      top of armhole， then straight down to bottom of sleeve or cuff.
I3.  From neck seam measure to shoulder point， then straight down to bottom of     
      Sleeve or cuff。
       
       
Apparel Product Standards
Measurement Guidelines for Finished Garments
J.sleeveCUFF/SLEEVE OPENING
J1.  Measure across opening of sleeve or cuff from side to side， x 2 for circumference.
J2。  Extended measurement – With cuff fully extended, measure across opening of
      cuff from side to side, x 2 for circumference.

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。