Time-out Timer Contents
User Safety Information (1)
Preparation (1)
Supplied Accessories (2)
Battery Information (2)
Accessory Information (3)
Attaching/Removing the Battery (3)
Attaching the Antenna (4)
Attaching/Removing the Belt Clip (4)
Attaching Remote Speaker/Microphone (4)
Rapid charger (4)
General (4)
Features (4)
Operation (5)
Notes (5)
Additional Remarks (6)
Getting Acquainted (6)
Basic Operation (7)
Auxiliary Feature (8)
Time-out Timer (8)
Battery Save (8)
Low Battery Warning (9)
Monitor (9)
CTCSS & CDCSS (9)
TTS (Two-Tone Signaling) (9)
Channel Scan (10)
Priority channel scan (10)
Scan Revert channel (11)
Busy Channel Lockout (11)
Optional Accessories (11)
Troubleshooting Guide (12)
Care and Cleaning (13)
Frequency Chart (14)
INFORMATION ON SAFE AND USING YOUR PORTABLE  RADIO.
* Only qualified technicians are allowed to repair this product.* To avoid electromagnetic interference and/or compatibility    conflicts, turn off your radio in any place where posted
notices instruct you to do so. Hospitals or health care facilities    may be using equipment that is sensitive to external RF    transmission.
When on aircraft, turn off your radio when airline crew
instructs you to do so.
* When in vehicles with an air bag, do not place a portable radio    in the area over an airbag or in the airbag deployment area.* Turn off your radio prior to entering any area with a
potentially explosive atmosphere. Do not remove, install, or    charge batteries in such areas.
* To avoid possible interference with blasting operations, turn off    your radio when you are near electrical blasting caps.
* Do not use any portable radio that has a damaged antenna.
If a damaged antenna comes into contact with your skin, a minor    burn may result.
* Do not expose the radio in direct sunlight for a long time or    place it close to a heating source.
or has been damaged during shipment, file a claim to the carrier immediately.
Supplied Accessories
1
* Antenna mark: TC-268(1)  shamrock.
TC-268(2)  grass green.
Charging the Battery
The battery is not charged in factory, so charge it before use. When first charging the battery after purc
hase or extended storage (more than 2 months), user may find battery capacity is lower than its normal capacity. However,repeating the charge/discharge cycle two or three times, its capacity will recover to normal.
Notes:
● Do not continue charging the battery if it is already fully charged
and do take the battery away from the charger, otherwise, the battery life will be shortened or damage may be caused to it.
● Turn the radio power OFF before charging. Using the radio
while charging its battery will interfere with correct charging.● When the battery operation time decreases even though it is      fully and correctly charged, that means the battery life is over,      please replace it with a new battery.
● Do not complete the battery terminals (short circuit ) or dispose      of the battery by fire.
● Never disassemble the battery
cover.
While placing the battery or the radio
with a battery into the charger
.*  Make sure the battery is well
connected with the charger connectors.
*  When rapid charging starts, red LED
glows; when charging is complete,
headset
Attaching/Removing the Battery
To attach the battery, match the four
grooves on the battery with the corre-
sponding guides on the radio. Slide the bat-
tery along the guides of the radio until the
battery latch at the bottom of the radio
locks.
To remove the battery, release the battery
latch and slide the battery away from the
radio .

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。