SOP标准模板
Standard Operating XXX
Department: Manufacturing
n: Back-end Packaging
n: XXX
Metal Detector
1.Metal detector should be calibrated before n starts.
2.The sensitivity and phase should be checked on the display screen.
3.The machine should be running smoothly without any noise or dust.
4.The flipper n should be tested with a 1mm XXX.
360度网站模板5.The machine should be checked every 0.5 hours during n with the test card.
6.XXX with the product name。date。and BH number。and sent to QA.
7.The machine should be cleaned and turned off before the end of the shift.
Bagging
1.Check the color and n date of the pouch roll according to the work order.
2.Remove any defective pouches。such as those with printing defects。foreign objects。or leaks.
3.Take 5-10 pouches from the lower conveyor belt and place them on the operating platform with the shiny side up and the small n facing up.
4.XXX.
5.Place the bag with the back facing up on the upper conveyor belt。Do not stack more than two bags.
Weighing
1.Place the electronic scale on a stable operating table and adjust it to be level.
2.Connect the power supply and turn on the switch to preheat (wait for the display).
3.The display should show "0" before weighing.
4.Place the bag with the back facing up on the scale to weigh it.
5.If the weight is not within the range。pour out the pouches and count them again to confirm if the bag is too light or too heavy。Feedback should be given to the XXX.
Note: XXX every half an hour according to the packaging n form。The metal detector should be checked every 5 minutes by the XXX and the packaging n form should be completed。The metal bags should be labeled with the product name。date。and BH number before being sent to QA.

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。