Multi Hybrid Control Panel
AW-RP505
Before attempting to connect or operate this product,
please read these instructions completely.
®
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIS TURE.
The lightning flash with arrowhead sym-
bol, within an equilateral triangle, is
intended to alert the user to the pres-
ence of uninsulated "dangerous voltage"
within the product's enclosure that may
be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilat-
eral triangle is intended to alert the user
to the presence of important operating
and maintenance (servicing) instructions
in the literature accompanying the appli-
ance.
The serial number of this product may be found on the bot-
tom of the unit.
You should note the serial number of this unit in the space
provided and retain this book as a permanent record of your
purchase to aid identification in the event of theft.
Model No.
Serial No.
SA 1965
SA 1966
CONTENTS
FEATURES (2)
PRECAUTIONS (3)
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS (4)
INSTALLATION OF PAN/TILT HEAD (19)
CONNECTIONS (22)
OPERATING PROCEDURES (26)
RACK MOUNTING (34)
SPECIFICATIONS (36)
ACCESSORIES (37)
-1-
•The Multi Hybrid Control Panel AW-RP505 is combined with the Multiport Hub (AW-HB505) to control up to five Pan/tilt Heads (AW-PH300) and Color Video Cameras (AW-E560).  With the Control Panel AW-RP505 con-nected to the multiport hub with three coaxial cables (5C-2V) and a single 10BASE-T straight cable (UTP category 5), and with the Multiport Hub connected to each camera and pan/tilt hea
d with three coaxial cables (5C-2V) and a single 10BASE-T straight cable (UTP category 5), the Control Panel performs various kinds of control on the cameras and pan/tilt heads, and sends and receives camera video signals and genlock signals.
•The maximum cable length from this control panel to the Multiport Hub is 10 meters.  The maximum cable
length between the multiport hub and the cameras and
pan/tilt heads is 500 meters.
•Head pan/tilt and lenz zoom/focus can be controlled at varying speeds with the servo control, and can be pre-
set at up to 10 points per pan/tilt head.
•With the auxiliary control input connector (AUX CON-TROL IN), pan/tilt, zoom, focus, and iris operations can
be externally controlled.
-2-
•Use only with AC Adaptor AW-PS301.
•Handle the control panel with care.
Dropping the control panel or subjecting it to a strong shock can cause a failure or an accident.•Operating temperature range –10°C to +45°C
Avoid using it in a cold place below –10°C or a hot place above +45°C because low or high temperature will adversely affect the parts inside.
•Switch power off before power cable connection or disconnection.
Be sure to switch power off before connecting or dis-connecting the power cable.
•Avoid outdoor use.
•Install the control panel more than 1 meter away from the monitors.
•Care
tiltPull out the power cable plug, and wipe the control
panel clean with a dry cloth. If it is extremely dirty, dip
a cloth into a diluted solution of kitchen detergent,
squeeze it hard, and wipe the product surfaces care-
fully.
-
3-

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。