Material Safety Data Sheet
Copyright, 2005, 3M Company.  All rights reserved.  Copying and/or downloading of this information for the purpose of properly utilizing 3M products is allowed provided that: (1) the information is copied in full with no changes unless prior written agreement is obtained from 3M, and (2) neither the copy nor the original is resold or otherwise distributed with the intention of earning a profit thereon.
This material safety data sheet (MSDS) is provided as a courtesy in response to a customer request.  This product is not regulated under, and a MSDS is not required for this product by the OSHA Hazard Communication Standard (29 CFR 1910.1200) because, when used as recommended or under ordinary conditions, it should not present a health and safety hazard.  However, use or processing of the product not in accordance with the product's recommendations or not under ordinary conditions may affect the performance of the product and may present potential health and safety hazards.
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME: Scotch brand No. 8663 Polyurethane Protective Tape; SJ8665 and SJ8667HS Radome
Boots or 8673 Clear
MANUFACTURER: 3M
DIVISION: Aerospace Aircraft Maint Division
ADDRESS: 3M Center
St. Paul, MN  55144-1000
EMERGENCY PHONE: 1-800-364-3577 or (651) 737-6501 (24 hours)
Issue Date: 09/13/2005
Supercedes Date: 11/17/2004
Document Group: 07-1862-7
SECTION 2: INGREDIENTS
Ingredient    C.A.S. No.% by Wt
POLYURETHANE Unknown  60 -  100
ACRYLIC ACID-ISOOCTYL ACRYLATE POLYMER 9017-68-9  7 -  13
SECTION 3: HAZARDS IDENTIFICATION
3.1  EMERGENCY OVERVIEW
Specific Physical Form:  Roll of Tape
Odor, Color, Grade:  CLEAR
General Physical Form:  Solid
Immediate health, physical, and environmental hazards:                          This product, when used under reasonable conditions and
in accordance with the 3M directions for use, should not present a health hazard. However, use or processing of the product in a manner not in accordance with the product's directions for use may affect the performance of the product and may present potential health and safety hazards.
3.2  POTENTIAL HEALTH EFFECTS
Eye Contact:
No health effects are expected.
Skin Contact:
No health effects are expected.
Inhalation:
No health effects are expected.
Ingestion:
No health effects are expected.
SECTION 4:  FIRST AID MEASURES
4.1  FIRST AID PROCEDURES
The following first aid recommendations are based on an assumption that appropriate personal and industrial hygiene practices are followed.
Eye Contact:    Flush eyes with large amounts of water.  If signs/symptoms persist, get medical attention.
Skin Contact:    Wash affected area with soap and water.  If signs/symptoms develop, get medical attention.
Inhalation:          No need for first aid is anticipated.
If Swallowed:            No need for first aid is anticipated.
SECTION 5: FIRE FIGHTING MEASURES
5.1  FLAMMABLE PROPERTIES
Autoignition temperature Not Applicable
Flash Point Not Applicable
Flammable Limits - LEL Not Applicable
Flammable Limits - UEL Not Applicable
OSHA Flammability Classification: Not Applicable
5.2  EXTINGUISHING MEDIA
Use fire extinguishers with class B extinguishing agents (e.g., dry chemical, carbon dioxide).
5.3  PROTECTION OF FIRE FIGHTERS
Special Fire Fighting Procedures:    Wear full protective equipment (Bunker Gear) and a self-contained breathing apparatus
(SCBA).
Unusual Fire and Explosion Hazards:    Not applicable.  No unusual fire or explosion hazards are anticipated.
Note: See STABILITY AND REACTIVITY (SECTION 10) for hazardous combustion and thermal deco
mposition information.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Accidental Release Measures: Not applicable.
SECTION 7: HANDLING AND STORAGE
7.1  HANDLING
Avoid prolonged or repeated skin contact.  This product is considered to be an article which does not release or otherwise result in exposure to a hazardous chemical under normal use conditions.
7.2  STORAGE
Not applicable.
SECTION 8:  EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1  ENGINEERING CONTROLS
Not applicable.
8.2  PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1  Eye/Face Protection
Not applicable.
8.2.2  Skin Protection
Not applicable.  Gloves not normally required.  Avoid prolonged or repeated skin contact.
8.2.3  Respiratory Protection
Under normal use conditions, airborne exposures are not expected to be significant enough to require respiratory protection.
8.2.4  Prevention of Swallowing
Not applicable.
8.3  EXPOSURE GUIDELINES
None Established
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Specific Physical Form: Roll of Tape
Odor, Color, Grade: CLEAR
General Physical Form: Solid
Autoignition temperature Not Applicable
Flash Point Not Applicable
Flammable Limits - LEL Not Applicable
Flammable Limits - UEL Not Applicable
Boiling point Not Applicable
Density    1.15 g/cm3 [@ 20 ºC]
Vapor Density Not Applicable
Vapor Pressure Not Applicable
Specific Gravity    1.15  [Ref Std: WATER=1]
pH Not Applicable
Melting point No Data Available
Solubility In Water Not Applicable
Solubility in Water Nil
Evaporation rate Not Applicable
Hazardous Air Pollutants 0 % weight [Test Method: Calculated]
Volatile Organic Compounds 0 % [Test Method: calculated per EPA method 24]
Percent volatile 0 % [Test Method: Estimated]
VOC Less H2O & Exempt Solvents 0 g/l [Test Method: calculated per EPA method 24]
Viscosity Not Applicable
SECTION 10: STABILITY AND REACTIVITY
Stability: Stable.
Materials and Conditions to Avoid:  None known
Hazardous Polymerization:  Hazardous polymerization will not occur.
Hazardous Decomposition or By-Products
Substance Condition
Carbon monoxide During Combustion
Carbon dioxide During Combustion
Irritant Vapors or Gases During Combustion
Hazardous Decomposition:  Under recommended usage conditions, hazardous decomposition product
s are not expected. Hazardous decomposition products may occur as a result of oxidation, heating, or reaction with another material.
SECTION 11: TOXICOLOGICAL INFORMATION
Please contact the address listed on the first page of the MSDS for Toxicological Information on this material and/or its
components.
SECTION 12: ECOLOGICAL INFORMATION
ECOTOXICOLOGICAL INFORMATION
Not applicable.
CHEMICAL FATE INFORMATION
Not applicable.
SECTION 13: DISPOSAL CONSIDERATIONS
Waste Disposal Method:  Dispose of waste product in a sanitary landfill.  As a disposal alternative, incinerate in an industrial or commercial facility.
Since regulations vary, consult applicable regulations or authorities before disposal.
SECTION 14:TRANSPORT INFORMATION
ID Number(s):
70-0000-4526-3,  70-0000-5607-0,  70-0000-6236-7,  70-0000-6237-5,  70-0000-8242-3,  70-0000-8400-7,  70-0061-2880-8,  70-0061-7863-9,  70-0061-7864-7,  70-0061-7865-4,  70-0061-7866-2,  70-0062-6990-9,  70-0062-6991-7,  70-0702-5833-3,  70-0702-5834-1,  70-0703-0504-3,  70-0703-7786-9,  70-0704-2776-3,  70-0707-0642-2,  70-0707-0643-0,  70-0709-1393-7,  70-0709-1394-5, 70-0709-1395-2,  70-0709-1396-0,  70-0709-1397-8,  70-0709-1398-6,  70-0709-1401-8,  70-0709-1402-6,  70-0709-1446-3,  70-0709-1447-1,  70-0709-1448-9,  70-0709-1449-7,  70-0709-1450-5,  70-0709-1451-3,  70-0709-1452-1,  70-0709-1453-9,  70-0709-1454-7,  70-0709-1455-4,  70-0709-1456-2,  70-0709-1457-0,  70-0709-1458-8,  70-0709-1459-6,  70-0709-1460-4,  70-0709-1461-2, 70-0709-1462-0,  70-0709-1463-8,  70-0709-1476-0,  70-0709-1477-8,  70-0709-1486-9,  70-0709-1487-7,  70-0709-1488-5,  70-0709-1489-3
Please contact the emergency numbers listed on the first page of the MSDS for Transportation Information for this material.
SECTION 15: REGULATORY INFORMATION
US FEDERAL REGULATIONS
Contact 3M for more information.
311/312 Hazard Categories:
Fire Hazard - No    Pressure Hazard - No    Reactivity Hazard - No    Immediate Hazard - No    Delayed Hazard - No
STATE REGULATIONS
Contact 3M for more information.
>reaction to a book or an article

版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。