information
Output (total): - packets, -
mac-mirroring mac-address mirroring functiondcasts, - multicasts, - pauses
mdi Specify mdi typeackets, 0 bytes
mirroring-group Specify mirroring-group pauses
mirroring-port Specify mirroring portffer failures
mld-snooping Configure MLD snooping characteristsions, 0 la
ndp Neighbor discovery protocol
Description: Ethern
ntdp Specify NTDP configuration information is not set
Media type is twisted pair, Po
oam OAM protocol
ping Ping function full-duplex mode
port Specify Port characteristicsduplex type is force link
port-isolate Port-isolate group informationenabled
The Maximum Frame
port-security Specify port-security configuration information%
PVID: 1
Mdi type: auto
qinq Specify 802.
0 broadcasts, 0 multicasts
shutdown Shut down this interfaceors, 0 runts, 0 giants, - throttles
smart-link Configure smart link 0 CRC, 0 frame, 0 overruns, 0 aborts
speed Specify speed of current portnored, - parity errors
storm-constrain Port storm-constrain
tracert Trace route function
Output: 0 output error
undo Cancel current setting
user-bind Bind user addressate collisions
virtual-cable-test display virtual cable test information carrier
Ethernet1/0/6 c
vlan-check Check the VLAN tag of incoming frames Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e268-6bf0
voice Specify voice VLAN
Description: Et
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]disp this
Loopback is not set
#
interface Ethernet1/0/1 is twisted pair, Port
port link-type trunkASE_TX
10 Specify speed as 10 Mbpsength is 1552
100 Specify speed as 100 Mbpso: 100%
auto Enable port's speed negotiation automatically link-type: access
Tagged
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]speed 10Untagged VLAN ID : 1
[XJ-YL-LTJ-S
3528P-Ethernet1/0/1]disp thist 300 seconds input: 0 packets/sec 0 byt
#/
interface Ethernet1/0/1
port link-type trunk Last 300 seconds out
port trunk permit vlan 1 114 2000 3000 to 3001 4000
Input (t
speed 10packets,
duplex full
stp disable
#-
returnasts,
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]d
half Half-duplex
0 C
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]duplex half
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]disp this
Output (total): - pa
#e
interface Ethernet1/0/1
port link-type trunk - multicasts, - paus
port trunk permit vlan 1 114 2000 3000 to 3001 4000ut (normal): 0 packets, 0 bytes
speed 10
duplex halfcasts, 0 mul
stp disableuses
#
return
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]-S3528P>system-view
System User View with Ctrl+Z.
****************************************************************************ace-number￡?
Copyright(c) 1998-2008 Huawei Technologies Co., Ltd.
bfd Specify BFD inte
Compiled Date : Jun 23 2008
CPU Clock Speed : 200MHz Border Gateway Protoco
Memory Size : 128MB
CPLD Version : 002 Specify BPDU tunn
PCB Version : Ver.D
command-privilege
............................................................................
cut Cut connection
............................................................................
dhcp DHCP configuration subcommand
............................................................................ DHCP Snooping
display
.
........................................................................... Specify 802.1X configuration informationS3528P>display l
............................................................................ Batch Commandning
<
file
............................................................................tem View: return to User View with Ctrl+Z.
flow-template S
............................................................................interface-type interface-number￡?
ftp Speci
.....................................................
% Unrecognized comm
igmp Specify IGMP configuration i
* no decompiling or reverse-engineering shall b
e allowed. *gmp-snooping IGMP snoopingommand found at '^' position.
******************************************************************************tem view commands:
acl Specify acl
User interface aux0 is available.y the interface configuration vie
Press ENTER to get started. Specify
<XJ-YL-LTJ-S3528P>
%Apr 26 12:00:27:823 2000 XJ-YL-LTJ-S3528P SHELL/4/LOGIN: Console login from aux Specify BFD interface pa
ipv6 Enable IPv6 functionality
0
<XJ-YL-LTJ-S3528P>
<XJ-YL-LTJ-S3528P>
<XJ-YL-LTJ-S3528P>ermediate System t
<XJ-YL-LTJ-S3528P>disp cu int Specify BPDU tunnel
<XJ-YL-LTJ-S3528P>disp cu in
lldp
duplex full Link L
stp disabley Protocol(8
#.
returnpecify
<XJ-YL-LTJ-S3528P>?on information
User view commands:local-user
backup Backup next startup-configuration file to TFTP server level
loopback-detectio
boot-loader Set boot loader
bootrom Update/read/backup/restore bootromigure MAC address
dhcp
cd Change current directorySpecify management-vlan
clock Specify the system clockle MIB style
cluster Run cluster commandoup Speci
dir List files on a file systemattributes
display Show running system informationn informationcify 802.1X configuration informati
fixdisk Recover lost chains in storage devicee to multicast sourceute Batch Comman
format Format the devicest Specify multicas
free Clear user terminal interface
ftp Open FTP connectioncast VLAN Specify flow template
lock Lock current user terminal interfacecovery protocol
ftp
mkdir Create a new directory Specify NQA (Network Quality An
more Display th
ntdp Run NTDP commands
ntp-service
ping Ping functionme Protocol) configurationing
pwd Display current working directory
in
quit Exit from current command view oam OAM protocol
reboot Reboot system
ospf Op
refresh Do soft resetration Protocol
rename Rename a file or directory Open Shortest Path First for IPv6
reset Reset operation
restore Restore next startup-configuration f
ile from TFTP serverMulticast)
hotkey
rmdir Remove an existing directoryon information
port-group Port group
[XJ-YL-LTJ-
send Send information to other user terminal interfacety configuration information ^
% Unreco
sftp Establish one SFTP connectioney Specify public-key module con
ssh2 Establish a secure shell client connection
<XJ-YL-LTJ-S3528P>
qos
stack Switch stack systemrvice)8P>
<XJ-YL-L
startup Specify system startup parameters Exit from current command viewmand found a
super Set the current user priority levels Specify RADIUS configuration inf
system-view Enter the System View************************************
<XJ-YL-LTJ-S3528P>saify RMON******
The current configuration will be written to the device. Are you sure? [Y/N]:yinterface aux0 is available
router Configure Router inform
Please input the file name(*.cfg)[flash:/vrpcfg.cfg]
rrpp Rapid Ring Protec
(To leave the existing filename unchanged, press the enter key):
save Save current configurationXJ-YL
flash:/vrpcfg.cfg exists, overwrite? [YJ-S3528P
<XJ-YL-LTJ-S3528P>ping 127.0.0.1 Specify SFT
PING 127.0.0.1: 56 data bytes, press CTRL_C to break
shutdown-interval ShutDow
Reply from 127.0.0.1: bytes=56 Sequence=1 ttl=255 time=1 ms-link Configure smart linknfiguration file to TFT
Reply from 127.0.0.1: bytes=56 Sequence=2 ttl=255 time=1 ms(Simple Network Management Protocol)boot loader
Reply from 127.0.0.1: bytes=56 Sequence=3 ttl=255 time=1 ms configuration information
cd
Reply from 127.0.0.1: bytes=56 Sequence=4 ttl=255 time=1 msH (secure shell) configuration informationystem clock
Reply from 127.0.0.1: bytes=56 Sequence=5 ttl=255 time=2 ms
<XJ-YL-LTJ-S3528P>tracert 127.0.0.1nstrain Port storm-constra
traceroute: Destination can not be a local addresstp Spanning tree protocoler los
<XJ-YL-LTJ-S3528P>disp cpu
super
Unit CPU usage: Modify super
2% in last 5 secondsice
10% in last 1 minutewitch-mode se
0% in last 5 minutes
ft
<XJ-YL-LTJ-S3528P>disp m?sysname
mac-addresst nameck
mac-forced-forwardingrminal interfachtmlborder
system
memory
mib-stylefunction
mirroring-groupCreate a new direc
mld-snooping
monitor-linkTr
ansm D
msdph
multica
<XJ-YL-LTJ-S3528P>disp memory Specify TELNET
System Total Memory(bytes): 83277840commands
Total Used Memory(bytes): 38018968 Specify TFTP configura
Used Rate: 45%nDisplay curre
<XJ-YL-LTJ-S3528P>disp ver
<XJ-YL-LTJ-S3528P>disp version Servert from current command
Huawei Versatile Routing Platform SoftwareSpecify time-range configuration informati
VRP Software, Version 5.20, Feature 5305P02 Do soft reset
tracert
Copyright (c) 1998-2008 Huawei Tech. Co., Ltd. All rights reserved.
track Specify track information
Quidway S3528P-EA uptime is 0 week, 0 day, 0 hour, 4 minutes Specify traffic configuration information
Quidway S3528P-EA
128M bytes DRAM Remov
und
32M bytes Flash Memoryl current settin
Config Register poi
Bootrom Version is 202k
[SubSlot 0] 24FE Hardware Version is REV.Dterminal interface
^
[SubSlot 1] 4GE Hardware Version is REV.Dan Configure VLAN
<XJ-YL-LTJ-S3528P>sys<XJ-YL-LTJ-S
voice
System View: return to User View with Ctrl+Z.
PING 192.168.1.1: 56 data bytes
vrrp
[XJ-YL-LTJ-S3528P]syscify configuration in
[XJ-YL-LTJ-S3528P]sys?
Request time
sysname
system-guardtim
[XJ-YL-LTJ
[XJ-YL-LTJ-S3528P]int eth1/0/1ut
Req
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]exit Request time out
% Unrecognized c
^cs ---
% Unrecognized command found at '^' position.
^ved
[XJ-YL-LTJ-S3528P-Ethernet1/0/1]quit found at '^' position.
<XJ
[XJ-YL-LTJ-S3528P]vlan 1
[XJ-YL-LTJ-S35
#d
vlan 1 posit
#n
vlan 114
description To-60.13.249.193/27-Acc-LTJ-S3528P]nce=3 ttl=255 time
[XJ-Y
#L
vlan 115]cfd
description To-YNS-HongYanDianZi ^
Reply from 127.0.
%
#n
vlan 2000ommand fo
description To-ATM.NMS
#
vlan 3000 to 3001-YL-LTJ-S3528P]cf
[XJ-YL-LTJ-S3528P]sys
^
% Incomplete
% Ambiguous command found at '^' position.-- 127.0.0.1 ping statistics --
[XJ-YL-LTJ-
[XJ-YL-LTJ-S3528P]disp cu\XJ-YL-LTJ-S3528P]nsmitted
^8P] 5 packet(s) rec
[X
% Unrecognized command found at00% packet lo
#[
vlan 1TJ-S35
#P
vlan 114mmer-tim
description To-60.13.249.193/27-Acc
#
vlan 115me Spec
description To-YNS-HongYanDianZiommand found at '^' position.-YL-
#J
vlan 2000
description To-ATM.NMSL-LTJ-S3528P]pi ?
#
vlan 3000 to 3001 ^**
#*
vlan 4000****
% A
description OA Netnd at '^' position.
#*
do
版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。
发表评论